Owners Manual

Two Linked Units Surface Mount Installation
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
1. Preparation for installation: As shown in Fig. 1,
use tool to drill holes as shown below. Make
sure the holes are properly aligned for a
linear installation.
2. Preparation for installation: As shown in
Fig. 2, Fix the drywall anchors (C) into the
hole on the ceiling.
3. Fix the mounting clips:
As shown in Fig 3., using the drywall screws (B)
to fix the mounting clips (A) on the ceiling. Fix
connecting bracket (F) and end brackets (I).
Leave bracket latches up.
4. Wiring:
As shown in Fig 4., install the power (D) and
dimming (E) wire on the input end. Install
power (G) and dimming (H) connecting cables
on opposite end.
Twist the input cables tight.
Twist the water-proof
connector tight.
Page: 3
REV: 6/21/18
Note: Connecting brackets and end brackets can be purchased seperately.
F: Connecting
B
racket
Qty: 1
I: End Bracket
K
it
Qty: 2
G: Connecting
P
ower Cable
Qty: 1
H: Connecting
D
imming Cable
Qty: 1
Connecting Bracket Kit: End Bracket Kit:
Operating Instructions VT Series
MaxLite TriMax LED Vapor Tight
®
Mounting Clips
Drywall
Screws
Hole
Drywall
Anchors