Owners Manual

© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Single Unit Surface Mount Installation
1. Preparation for installation:
As shown in Fig. 1, use tool to drill two holes
with a diameter of 5.5mm on the ceiling with a
hole distance of 24.5mm. Use the same method
to drill two additional properly aligned holes.
2. Preparation for installation:
As shown in Fig. 2, fix the drywall
anchors (C) into the holes on the ceiling.
3. Fix the mounting clips:
As shown in Fig 3., use the drywall screws (B)
to fix the mounting clips (A) on the ceiling.
4. Fix the screws:
As shown in Fig 4., install the screw and
nut (part of each mounting clip) into the
mounting clips (A).
5. Install power and dimming cables:
After attaching power cable (D)
[and dimming cable when required (E)]
See Fig. 5.
Page: 2
REV: 6/21/18
Operating Instructions VT Series
MaxLite TriMax LED Vapor Tight
®
Hole
Ceiling
6. Fix the fixture:
Gently snap the fixture into mounting clips (A)
into the rail located on the back of the fixture
as shown in Fig. 6. Finally, fasten the screws
on the mounting clip.