Owner's Manual

© Copyright 2015. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page : 2
REV: 7/21/2015
Operating Instructions SEC Series
MaxLite
®
LED SECURITY LIGHT
General Wiring Diagram
CAUTION: Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
Connecting fixture to AC source supply:
All units must be individually connected to the AC supply. (see page 1 for voltage by model)
Black = Line
White = Neutral
Green = Ground
AC wiring instructions
1. Connect supply wires to quick connect supplied: Black/Hot supply to quick connect with black wire. White/Neutral supply to
quick connect with white wire. Confirm connections are secured.
2. Connect ground wire to quick connect with green wire. Confirm grounding connection is secured.
Installation & Operation
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the fuse box.
Turning the power off using the light switch is not sufficient to prevent electrical shock.
1. Use a screwdriver to loosen (2) screws securing fixture cover. Remove fixture back plate from fixture.
2. Use Philips screwdriver to slide wire way covering from back plate of housing.
3. Use 1” thread ½ NPT fitting (not supplied) through back of housing until flush with outside surface.
4. Add ¼” bead of exterior grade silicone sealant around the perimeter of the wall pack.
5. Feed power leads from junction box through NPT fitting into the exterior of the fixture.