Owner's Manual

Wiring Diagram
I
nst
al
l
at
i
on
I
ns
t
r
uct
i
ons
Installation Steps:
1. Shut off power to existing fixture. Disconnect the black and the white power supply wire to existing ballast.
2. Remove and discard the host fixture lamp(s).
3. Remove ballast cover, ballast, sockets/bracket and wiring.
4. For 4ft installations break off the two end pieces of the provided bracket and install onto fixture (Fig. 2)
Note: For 8ft installations, use the center piece of the provided bracket to connect two 4ft pieces together.
5. Make electrical connections.
6. Install LED retrofit with quarter turn provided.
7. Install lens, be sure it snaps into place along the entire length of the fixture. (Fig. 3)
8. Electrically activate the fixture.
Operating Instructions RS Series
MaxLite RS Series
®
© Copyright 2017. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 2
REV: 11/09/17