Installation Sheet

Operating Instructions ECO Series
MaxLite ECO Series 6” & 8” Commercial Downlight Retrofit
®
© Copyright 2019. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Installation & Operation (Continued)
After matching the correct size reflector to the correct sized
frame, we can begin installation of the reflector.
1. The correct orientation for the frame is with the junction
box placed on top of the frame.
2. Attach the clips provided with the RRECO fixture onto
the Recessed Frame Kit by pressing the gap on the clip
into the lip of the fixture. The teeth of the additional clip
should be facing the same direction as the other clips.
3. Pass the cable through the opening of the Recessed
Frame so that the top of the reflector can pass through
the bottom of the recessed Frame.
4. Finally, press the RRECO reflector into the Recessed
Frame. The additional clips will provide the friction force
to keep the reflector from sliding out.
Page: 4
REV: 12/11/19