Owner's Manual

© Copyright 2016. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Installation & Operation
1. Turn off the power before installation, Remove the diffuser existing bulb if
necessary and remove the existing trim. Attach the relamping label to the
inside of recessed luminaire housing.
2. As shown in Figure 1, Twist the lamp base into the lamp holder.
3. As shown in Figure 2, Connect the lamp connector with lamp base connector.
4. The lamp at both ends of the spring are arranged inside the lamp holder bayonet,
(as shown in Figure 3) through the spring pressing on both sides, so that it can be on
both sides of the bayonet.
5. As shown in Figure 4, Push the LED retrofit trim into the recessed light fixture, allowing
the torsion springs to pull the LED trim up into the recessed light fixture. Continue to push
the LED trim until its outer edge is flush against the ceiling surface.
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the
fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
Operating Instructions RR6 Series
MaxLite LED 6” Downlight Retrofit
®
Page: 2
REV: 12/06/16