Installation Sheet

Operating Instructions RCF Universal Downlight Series – CCT Selectable
MaxLite Universal Downlight RCF Series – CCT Selectable
®
New Construction Installation
1.) Make sure the POWER IS TURNED OFF at the source to the recessed frame in which you are
installing the product.
2.) Attach the carabiner safety clip to a structural support (Figure 1)
3.) Insert lamp conduit into the J-box and wire to power source (black to hot, white to neutral, green to ground)
(Figure 2) Reattach J-box cover when done.
4.) Toggle the CCT Selector on the top of the unit to the desired color temperature (CCT) (Figure 3).
5.) Squeeze the two tension clips so they are in an upright position and insert lamp into the frame. (Figure 4)
6.) Once the luminaire is inside the frame, release the tension clips and continue pushing the luminaire into
the frame until securely fixed and flush with ceiling (Figure 5)
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 3
REV: 3/25/21