Installation Sheet

Retrofit Installation
1.) Make sure the POWER IS TURNED OFF at the source to the recessed frame in which
you are installing the product.
2.) Remove the existing lamps and trim. (Figure 1)
3.) Attach the carabiner safety clip to the existing fixture frame or support structure. (Figure 2)
4.) Open the J-box and cut away all wires connected to the ballast. Insert lamp conduit into the J-box
and wire to power source (black to hot, white to neutral, green to ground) (Figure 3) Reattach J-box
cover when done.
5.) Toggle the CCT Selector on the top of the unit to the desired color temperature (CCT) (Figure 4)
6.) Squeeze the two tension clips so they are in an upright position and insert lamp into the frame. (Figure 5)
7.) Once the luminaire is placed within the frame, release the housing clips and continue pushing the luminaire
into the frame until securely fixed and flush with ceiling (Figure 6.) Completed retrofit shown in Figure 7.
General Wiring Diagram
CAUTION: Turn off electrical power at fuse
or circuit breaker box before wiring fixture to
the power supply.
Input Rating: 120-277V 50/60 Hz
Black = Line
White = Neutral
Green = Ground
Operating Instructions RCF Universal Downlight Series – CCT Selectable
MaxLite Universal Downlight RCF Series – CCT Selectable
®
(+) LINE
(-) COMMON
GROUND GREEN / YELLOW-GREEN
WHITE
BLACK
Light
Fixture
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 2
REV: 3/25/21