Installation Sheet

Operating Instructions MLFPxxG4 Series
MaxLite FlatMAX LED Flat Panels
®
T
M
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 4
REV: 11/03/21
Suspended Installation
Cable kits sold separately:
• MLG4CHK • ML24G4CHK
Minimum length: 3.5 in.
Maximum length: 36 in.
1.) Position the screw through the Support. (Fig. 1)
2.) Drive the screw through the desired location on the ceiling until the
Support is flush with the surface. (Fig. 2)
3.) The cable has two ends, one free and the other with a Latch Hook.
Secure the free side through the pin end of the Locking Terminator.
(Fig. 3)
4.) Pass the cable through the hole in the Support; screw the Locking
Terminator into the Support. (Fig. 4, Fig. 5)
5.) Locate the clips on the rear of the fixture. Secure the Latch Hook
to the fixture clips. (Fig. 6)
6.) Cable length can be shortened by feeding length of the cable
through the Locking Terminator. To release the Locking
Terminator, push the pin down and pull the cable.