Installation Sheet

Recessed Mount
1.) Bend hang buckle by 90°, making it vertical to the rear cover of
the flat panel fixture. (Fig. 1A) Bend the top part of the hang
buckle 90° (Fig. 1B) and repeat on all hang buckle’s.
2.) Turn off power and remove the ceiling panel. (Fig. 2)
3.) Place the troffer into T-bar. Ensure the troffer is attached to
the ceiling. (Fig. 3)
Surface Mount Installation
Surface mount kits sold separately:
• ML14G4SMK • ML22G4SMK • ML24G4SMK
Clip is used for positioning (NOT for mounting)
Clip
Surface Mount Kits Assembly
Fix the frame on
the ceiling
Insert LED panel to
the frame
Fix “L” bracket to
the frame
Installation is complete
Please make sure the frame is assembled well before fixed on ceiling
x2
x2
6 screws 8 screws 6 glue nails
detail
ceiling
ceiling
Operating Instructions MLFPxxG4 Series
MaxLite FlatMAX LED Flat Panels
®
T
M
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 3
REV: 11/03/21