Installation Sheet

c-Max™ node Installation Instructions (Applicable only on CR models)
1. Remove the silicone plugs from the USB-C receptacle and the screw hole (see Fig. 1).
2. Plug the c-Max™ into the USB-C receptacle via the USB connection (see Fig. 2).
3. Secure the c-Max™ node in place by fastening the included M3 button head screw with a Hex (Allen) key
(not included). Once the screw is secured, cover it with the included silicone cap (see Fig. 3 - drawing for
illustration only, actual screw may look different.)
Note: For samples including a hex screw, use a 2.5mm Allen key or SAE equivalent 3/32.
Note: In motion sensor models, the USB-C receptacle if present would no longer be functional.
Operating Instructions MLFPxxG4 Series
MaxLite FlatMAX LED Flat Panels
®
T
M
FIGURE 1
FIGURE 2
FIGURE 3
FI
GURE
1
FIGURE 2
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 10
REV: 11/03/21