Installation Sheet

Operating Instructions MLFPxxG4 Series
MaxLite FlatMAX LED Flat Panels
WARNING:
RISK OF ELECTRICAL SHOCK
• Turn off the electrical power at fuse or circuit breaker box
before wiring fixture to power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the
luminaire label information.
• Make all electrical and grounded connections in accordance with
the National Electrical Code and any applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
CAUTION:
RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from carton,
installing, servicing or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
• Ensure fixtures are properly secured to T-bar grid, ceiling, using wire, or aircraft cable capable of
supporting 100 lbs. minimum.
CAUTION:
RISK OF FIRE
• Keep combustible and other materials that can burn away from luminaire and lamp/lens.
• MIN 90°C SUPPLY CONDUCTORS.
Models:
MLFPxxG4 Series
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 1
REV: 11/03/21
®
General Safety Information
• To reduce the risk of death, personal injury or property
damage from fire, electric shock, falling parts,
cuts/abrasions, and other hazards read all warnings
and instructions included with and on the fixture box
and all fixture labels.
• Commercial installation, service and maintenance of
luminaires should be performed by a qualified licensed
electrician.
• DO NOT INSTALL DAMAGED PRODUCT!
P
icture is for illustration purposes only.
Your model may vary.
T
M
Included in the box:
• LED Flat Panel Fixture
• Junction Box
• Instructions