Owner's Manual

Mounting Instructions
© Copyright 2016. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
2.) Remove the ceiling tile at an appropriate location
where the product is to be installed, and raise the
product above the bar.
3.) Place one end of the product on the T-bar
4.) After securing the product on the T-bar with hang
bracket (as shown in step 1), secure panel
to the ceiling with aircraft cable or wires capable of
supporting 100lbs minimum.
5.) With the power turned off, remove the cover of the
junction box. Remove the knock-out(s), feed the
wire through and connect according to the wire
diagram (shown above).
6.) Close the cover of the junction box.
Optional Suspended Mounting
1.) Fix the suspension wire fixer on the ceiling
2.) Put suspending cable on the hooks
3.) Fix the suspension wire on the ceiling
4.) Connect input wire 100-277V
Operating Instructions MLFP22EP, MLFP14EP, MLFP24EP Edge Lit Series Panels
MaxLite FlatMAX LED Edge Lit Panels
®
TM
(Kit sold seperately)
Page: 3
REV: 10/20/16
1.) Bend hang bracket by 90°, making it vertical to the
rear cover of panel light (Figure 1A). Bend hang
bracket’s top part 90° (figure 1B). Do so for all
hang brackets.