Owners Manual

© Copyright 2017. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Mounting Instructions
Before installation, ensure if power supply is disconnected. Cables must be connected in accordance
to instruction and proper standing rules.
1. Locate drill holes for mounting brackets shown in Fig 1. Use hardware found in hardware kit.
Mount bracket to surface.
2. Pre-attached lens buckles to housing
3. Detach LED tray from fixture as shown in Fig 2.
Be sure not to let the tray flex or bend and do not stack the trays.
4. Attach body to mounting clips as shown in Fig 3.
5. Locate tether when opening to install fixture body as shown in Fig 4.
6. Snap connect tether to gear tray before making electrical connection as shown in Fig 5.
7. Connect power to driver. Follow General Wiring Diagram on page 2 for reference.
Make sure the power supply is disconnected before installing.
8. Reattach LED tray to fixture by reversing step 2.
9. Install lens as shown in Fig 6. Use the buckles provided in hardware kit to securely
attach lens to body fixture.
10. Restore power.
Operating Instructions LSV Series
MaxLite LED Vapor Tight Linear Fixture
®
Page: 3
REV: 03/10/17