Owner's Manual

© Copyright 2016. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page : 3
REV: 01/13/16
Operating Instructions LSU Series
MaxLite
®
LED UTILITY WRAP FIXTURES
Mounting Instructions-Cont’d
3. Select wiring access point and remove appropriate knockout.
4. Select installation point and locate studs.
5. For rear access points feed wires through hole.
6. Using 1” mounting screw or 3”x3/16 toggle bolts, secure fixture in place using keyhole slots provided.
7. After making wiring connections, replace wire cover and diffuser into place.
8. Secure lens to housing by inserting clips at both ends of the fixture, as shown in the image below.
9. Restore power to branch circuit and energize the luminaire.