Owner's Manual

© Copyright 2016. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page : 2
REV: 01/13/16
Operating Instructions LSU Series
MaxLite
®
LED UTILITY WRAP FIXTURES
General Wiring Diagram
CAUTION:
Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
Connecting panels to AC source
supply:
All units must be individually
connected to the AC supply.
(120-277 VAC)
Black = Line
White = Neutral
Green = Ground
Operating characteristic:
Voltage input: 120-277V 50/60 Hz
Operating temp: -4 F to 104F
**Consult with dimmer control manufacturer’s wiring instructions and see below for optional wiring configurations
Mounting Instructions
Before installation, ensure if power supply is disconnected. Cables must be connected in accordance to
instruction and proper standing rules.
WARNING: During installation make sure fixture housing is not over torqued or bent on either side.
Fixture must be level if not prismatic lens will not sit properly in fixture housing causing the lens to fall.
1. Remove lens and wire way cover. Slide lens toward one end while lifting opposite end clear of fixture
housing. If not clearing easily, ensure lens has slide past retainer clip inside the end cap.
2. Next squeeze both sides of wire cover until they clear metal tabs and remove cover.
! !
!
!
!
!
!
!