Owners Manual

General Wiring Diagram
CAUTION: Turn off electrical power at fuse
or circuit breaker box before wiring fixture to
the power supply.
Connecting panels to AC source supply:
All units must be individually connected to
the AC supply. (120-277 VAC)
Black = Line
White = Neutral
Green = Ground
Operating characteristic:
Voltage input: 120-277V 50/60 Hz
Operating temp: -4°F to 104°F
**Consult with dimmer control
manufacturer’s wiring instructions
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 2
REV: 05/03/18
Operating Instructions LSU Series
MaxLite LED Utility Wrap Fixture
®
Mounting Instructions
Before installation, ensure if power supply is disconnected. Cables must be connected in accordance
to instruction and proper standing rules.
1. Remove lens and wire way cover. Slide lens toward one end while lifting opposite end clear of fixture
housing. If not clearing easily, ensure lens has slide past retainer clip inside the end cap.
2. Next squeeze both sides of wire cover until they clear metal tabs and remove cover.
3. Select wiring access point and remove appropriate knockout.
4. Select installation point and locate studs.