Owner's Manual

Operating Instructions LSP Series
MaxLite Polygon Linear LED Light
®
© Copyright 2016. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com
Page: 3
REV: 6/07/16
A. Surface Mounting Type (Continued)
1.) Affix the Mounting Bracket to the ceiling/wall using the two bracket screws as illustrated in Pic.1.
2.) Connect the Mounting Bracket and the Main Body of the light fixture using the fall protection safety strap.
Connect AC wires to the light fixture as shown in Pic.3.
3.) For the convenience of installation, lock the fixture screws with a lock washer through hole.
Then fix lighting fixture to surface mounting bracket tightly as shown on the pic. 1-1.
CAUTION:
• While attaching the light fixture to the bracket, make sure no cables/wires are neatly enclosed inside.
• Wires extruding through gaps will not allow proper installation, and may cause malfunction and safety hazard.
• Turn on the power only after making sure the bracket and the light fixture are firmly attached.
B. Pendant Type
1.) Connect each of the two Triangle Ring on the light fixture to two cables (not included with the product)
properly fixed to the ceiling as shown in Pic.2.
CAUTION:
• Pendant cables or rods (sold separately) must be of proper strength and securely fastened to the ceiling.
• Improper hanging of the light fixture may lead to injury or fire.
• Connect AC wires to the light fixture as shown in Pic.3.
• Turn on the power only after making sure the light fixture is securely attached.
1.) Connection to AC Input as shown in Pic.3 Peel off ~12mm sheath from
ceiling/wall lead-in wire, and connect to AC input wire (white/black) of
the product.
* Once connecting a number of luminaires in paralled, utilizing an internal wiring, we
recommend to restrict the number of luminaires as follow. (40W15 units, 60W12
units, 80W 10 units)
2.) For dimming the light, connect the dimming signal cable as shown in
Pic.4
- Connect the Signal Input Cable (Violet) to Dimming Signal Output
Cable (Violet).
- Connect the Signal Input Ground Cable (Gray) to the Signal Output
Ground Cable (Gray)
3.) For dimming more than two light fixture at the same time, signal cable
should be connected in a parallel way as below to control dimmer.
Connection
* 50 pcs possible to be connected by control wires (Recommend condition: AWG24 or
more thicker wire, max. separation distance 3M) line voltage: Dim_Min 1V ~ Dim_Max10V
CAUTION:
• Poor connection may cause damage to the product through short circuit, or cause injury and property damage
from electric shock or fire.
• Ground (green) wire must be attached to ground line-in to prevent electric shock hazard.