Owner's Manual

© Copyright 2016. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 2
REV: 6/07/16
Operating Instructions LSP Series
MaxLite Polygon Linear LED Light
®
Please read this manual before installing and using this product.
Product images in this manual may be different from actual product due to quality improvements.
This product is a high-tech electronic lighting equipment which uses Light Emitting Diodes (LED) as light source.
Its compact design is optimized through optical engineering, and produced to high quality standards with
rigorous inspection procedures.
※ This product was developed for climate controlled areas, and any exposure to extreme weather
conditions can result in condensation.
CAUTION:
• When installing light fixtures, to avoid the trip of ground fault circuit interrupter, less than 30 of light
fixtures are allowed to be installed for one circuit interrupter.
• Unstable installation and mounting may cause the fall of light fixture, fire, and electric shock.
• Connect the AC cable to the AC connector securely. Unstable connection may cause heat generation
and fire by poor insulation.
• Turn off the power switch before starting installation of light fixture.
Specification
Included Parts Depending on Mounting Type
General Wiring Diagram
CAUTION: Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
Wiring:
1.) Connect the black fixture wire to the (+) LINE supply wire.
2.) Connect the white fixture wire to the (-) COMMON supply wire.
3.) Connect the green fixture wire to supply ground wire.