Owner's Manual
Operating Instructions LSP Series
MaxLite Polygon Linear LED Light
© Copyright 2016. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com
Page: 1
REV: 6/07/16
®
General Safety Information
For Contractors:
WARNING:
• Light fixtures should only be installed by qualified electricians.
• Be sure to use proper mounting method and hardware rated for the weight
of the light fixture.
• Improper installation may lead to personal injury and property damage
from falling fixtures, fire, or electric shock.
• Make sure that all electric power cables are connected properly.
• Poor electric connection may cause fire from excessive heat generation.
• All electric equipment should be properly grounded according to local
codes and standards.
CAUTION:
• When installing multiple light in an area, be sure to maintain proper
distance between each light fixture.
• Use proper safety equipment such as insulated gloves when
installing/removing, connecting/disconnecting light fixtures.
For Users:
WARNING:
• Installing electrical light fixtures by unqualified person is prohibited by law.
• Light fixtures should only be installed by qualified electricians.
• Do not add or remove parts, or make any other alterations to the fixture, as
this may cause fire and electric shock.
• Avoid installing fixtures in damp or wet locations, which may cause short
circuit, electric shock, and fire.
• Do not put any metal or flammable objects through any gaps or openings
in the fixture.
• If any abnormality such as smoke or burning smell is detected, turn off the
electric power immediately and contact an electrician for repair.
Do not operate this or any other light fixture outside +/-5% range of the
rated voltage. This product is for indoor use only. Outdoor usage may
cause electric shock or fire.
Input Voltage: AC120V-277V
Operating Temperature: -4°F - 104°F
Picture is for illustration purposes only.
Your model may vary.