Owners Manual

Operating Instructions LRK Series
MaxLite LED LENSED RETROFIT KIT (2x2 & 2x4)
®
© Copyright 2017. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 3
REV: 2/14/17
1. Parts:
• Main fixture body - 1ea
• Screw - 8ea
• Lamp bracket - 2ea
• Coil protective ring - 2ea
Installation & Operation
2. Before installation, DISCONNECT ALL
INCOMING POWER TO FIXTURE,
remove all electrical parts and the ballast
compartment cover leaving only the
supply and grounding leads.
3. Attach the Lamp Brackets on both sides
of the troffer (between existing fixture
housing and Tgrid) with screws.
4. Install Door Frame to Lamp
Brackets.
5.A Locate the swing door supports located on
each end of the Lamp Bracket. Install the
swing door hinges into the keyholes on the
Lamp Brackets.
5.B Hang safety cable on both sides of lamp bracket.
6. Make sure power is switched
OFF before starting work using this
LED driver schematic:
7. When taking off the LRK, loosen locking
latch, move LRK follow arrows forward 0.4”
then open the LRK.