Installation Instructions

Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the
fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
Step 1: Make sure the circuit breaker that supplies power to the fixture is turned off.
Step 2: Remove lens or diffusion cover on the lighting fixture.
Step 3: Remove the existing T8/T12 fluorescent tubes.
Step 4: Remove the ballast cover and identify the line and neutral wires running from the breaker
box to the ballast and confirm the power is off using a voltmeter.
Step 5: Ensure that the fixture contains non-shunted
G13 bi-pin lamp holders. If not, remove
Shunted lamp holders and install non-shunted
lamp holders.
Step 6: Cut the line and neutral wires at the ballast,
as well as all remaining wires at the ballast
(see Figure 1).
Step 7: Remove Ballast (and starter if present).
Dispose of removed ballast in accordance
with government regulations in your area.
Step 8: For single-ended wiring, please see
Figure 2a, 2b, 2c or 2d.
Step 9: Reinstall the ballast cover to hide all wire.
Step 10: IMPORTANT: Peel off the provided caution
label and install on a visible location inside the fixture.
Installation & Operation - Single-Ended Wiring
Label pictures are for illustration purposes only.
- Black
+ Red
Driver
0~10V Dimming
+
-
Purple
Gray
~
L N
AC
- Black
+ Red
Driver
0~10V Dimming
+
-
Purple
Gray
~
L
N
AC
- Black
+ Red
Driver
0~10V Dimming
+
-
Purple
Gray
~
L N
AC
- Black
+ Red
Driver
0~10V Dimming
+
-
Purple
Gray
~
L N
AC
Figure 2a
Figure 2b
Figure 2c
Figure 2d
Kit Model: L11.5T8EX4xxDDR1L11
Lamp Model: L11.5T8EX4xx “xx” = CCT: 35, 40, 50 or 65
- Black
+ Red
Driver
0~10V Dimming
+
-
Purple
Gray
~
L N
AC
- Black
+ Red
Driver
0~10V Dimming
+
-
Purple
Gray
~
L N
AC
Operating Instructions L11.5T8EX4xx Series
MaxLite External LED T8 - 4FT
®
© Copyright 2019. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 2
REV: 1/03/19