Installation Instructions

Mounting Instructions
Hook Mounting:
1. Push down on the retainer spring on the hook until there is enough space to secure the hook to the
ceiling structure or pendant chain Figure 1.
2. Once the hook is securely mounted, release the retainer sprint to its original position.
3. Connect the power cord to supply wires using UL listed wire connectors.
Junction Box/Pendant Mounting:
1. Remove four screws shown in Figure 2 to remove driver cover from luminaire.
2. Remove driver from driver cover for easier access to NPT opening.
3. Thread the 3/4" pendant stem onto driver box cover.
4. Feed the power cord through the pendant stem and secure the pendant stem to the driver box with
a lock nut Figure 3.
5. Reassemble fixture.
6. Connect the power cord to supply wires using UL listed wire connectors.
© Copyright 2017. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 3
REV: 11/29/17
Operating Instructions HP Series
MaxLite HP Series Round Highbay
®