Owners Manual

Mounting Instructions
CAUTION: Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
Aircraft Cable Mount:
Operating Instructions HL Series
MaxLite LED Linear HighBay Fixtures
®
Locate a structural member and inspect it for
damage. Secure the aircraft cable around the
member and run it through the gripper to fas-
ten it. The cable enters and exits through the
side of the gripper. Adjust the fixture height
by drawing the cable through the gripper,
refer to Fig. 1.
Secure the bottom aircraft cable onto the LED high bay
by inserting the toggles through the 0.375” hole, refer to
Fig. 2.
Chain Mount:
Run the chain link through both
V-hooks and attach the hooks onto the
fixture, as shown in Fig. 1.
Locate a secure structural member and inspect it
for damage. Secure the chains around the member
and lock it with the S-hook, as shown in Fig. 2.
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 3
REV: 08/13/18