Owner's Manual
© Copyright 2017. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
Page: 2
REV: 8/14/17
Installation & Operation
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the
fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
REMOVING UN-NEEDED PARTS (FIG. 1)
1. Shut off the power at the circuit breaker. Remove diffuser, old sockets and
lead wires, retain all other parts including the crossbar.
2. Twist the ceiling pan (D), to loosen and remove via the key hole slots.
You should have access to the junction box now.
3. Carefully unpack your new retrofit kit and lay out all the parts on a clear area.
Take care not to lose any small parts necessary for installation.
Operating Instructions FRK Series
MaxLite Flush Mount Retrofit Kit
®
INSTALLATION STEPS:
4. Route LED retrofit kit wire harness wires (1 white, 1 black) and ground wire
(1 green) through wire opening in fixture. Confirm wires will not be pinched by
round LED mounting plate or other fixture hardware when reassembled.
5. Secure the retrofit to the fixture using one of the three installation options
available for retrofitting:
6. Connect wire harness leads to mains wiring inside junction
box using (3) wire nuts/connectors (WAGO)
a. Green wire to ground wire (bare or green)
b. Black or blue wire to line conductor (black)
c. White wire to neutral conductor (white)
7. Place the provided label in the outer space of the luminaire
after the LED engine installation has been completed. Label
must be visible.
8. Re-attach and secure the lens to luminaire. (Luminaire will work with or without diffuser)