Cut Sheet

Wiring Diagram
Installation Instructions
1.) Twist lens cover counter-clockwise to remove from Disc Light.
2.) Connect supply wires to fixture wires and insulate with proper size wire
(See wiring diagram above.)
a.) Connect incoming ground wire (green or bare) to fixture ground wire (green
or bare).
b.) Connect incoming common (white) wire to fixture common (white).
c.) Connect incoming hot (typically black) wire to fixture black wire.
3.) Attach the fixture to the outlet box by fastening supplied 1½"
outlet box screws through canopy keyholes. Make sure Disc Light
is flush to the ceiling. (Fig. 1)
4.) Replace the lens back on to the Disc Light by reversing step 1.
Installation onto outlet box:
Note: Provide electrical service according to the "National Electrical Code" or your local electrical code to the
outlet box.
© Copyright 2018. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 2
REV: 9/10/18
Operating Instructions Disc Light Series
MaxLite LED Disc Light
®