Owner's Manual

Operating Instructions LED Bollard - BL-CL & BL-MO Series
MaxLite LED Bollard Installation
These instructions should be followed to minimize condensation of moisture on the inside of the lens.
IMPORTANT:
Read instructions carefully before installing.
• This fixture must be installed by a qualified electrician.
• WARNING - Risk of fire or electrical shock.
• WARNING - Make certain power is switched OFF before starting installation or attempting any maintenance.
• This fixture must be wired in accordance with the National Electrical Code (NEC) and applicable local Codes
and Ordinances. Proper grounding is required to insure personal safety. Observe all grounding procedures.
• Silicone sealant, used to seal the end of the wiring conduit.
• Spray expanding foam, used to fill and seal the base of the bollard body.
STEP 1:
Remove the base from the bollard and retain the set screws to use when reinstalling the bollard body. Install the
bollard anchor bolts and attach the bollard base plate to them. The method used to set the anchor bolts is dependent
on the installation location and any applicable codes and ordinances, and are not a part of these instructions. Make
sure the conduit containing the line feed is located within the base plate area and will extend up inside the body of the
bollard when the bollard is placed on the base.
STEP 2:
Completely seal the exposed end of the wire conduit using the silicone sealant. (Figure 1)
STEP 3:
Remove the head of the bollard by loosening the set screws located on the outside of the bollard body underneath
the head plate and place the head and set screws aside. Place the bollard body on the installed base and secure to
the base using the set screws retained in Step 1.
STEP 4:
Fill the bottom of the bollard with approximately 5 inches of spray expanding foam, ensuring the foam makes
complete contact around the conduit and the inside of the bollard body. (Figure 2)
STEP 5:
Allow time for foam to expand, then visually inspect to confirm the foam does not contain gaps between the foam
and the conduit, or the foam and the inside of the bollard body. (Figure 3)
STEP 6:
Complete the bollard installation following all NEC and applicable local Codes and Ordinances.
© Copyright 2017. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 1
REV: 10/17/17
®
General Safety Information
Materials Needed
Installation