Safety Data Sheets (SDS)
SECTION 6: HEALTH HAZARD DATA 
Not applicable to the intact lamp. The luminescent materials are contained within the 
glass tubers. Tube breakage may result in some exposure to phosphor powder dust, 
mercury and small amounts of tin, lead, and bismuth. No adverse effects are expected 
from occasional exposure to broken lamps. Prolonged or frequent exposure should be 
avoided through use of adequate ventilation during disposal of large numbers of lamps 
as 
a matter of good practice. 
EMERGENCY FIRST AID: Normal first aid procedures for glass cuts if such occur 
through the lamp breakage. 
SECTION 7: PRECAUTIONS FOR SAFE HANDLING AND USE 
For indoor/outdoor use where not subjected to the weather. Not for the use in lighting 
devices controlled by dimmers and other electronic controls. Reliable operation down to
–20 degrees Fahrenheit (wind chill not a factor.) 
WASTE DISPOSAL METHOD: Toxicity law Characteristics Leaching Procedure 
(TCLP) promulgated by the U.S. Environmental Agency (EPA) tests of used or spent 
fluorescent lamps indicate some types of lamps may be classified as characteristic 
hazardous waste. TCLP test results for fluorescent lamps vary tremendously from 
laboratory to laboratory. Lamps from all manufacturers exhibit the same phenomena. 
The National Electrical Manufact
urers Association (NEMA) is working closely with the 
EPA for clarification and guidance. 
Disposal of spent lamps may be regulated if they are added to other regulated wastes or 
disposed in large quantities. If small quantities of these lamps are discarded in an 
ordinary trash, method of lamp disposal may not be affected much. Customer should 
review their waste handling practices to assure that they ar
e properly disposing of waste 
lamps. 
SECTION 8: CONTROL MEASURES 
Respiratory Protection: Appropriate dust mask should be used if large volumes of lamps 
are being broken for disposal. 
Ventilation: Avoid inhalation of any airborne dust. Provide local exhaust when disposing 
large quantities of lamps. 
Hand and Eye Protection: Appropriate hand and eye protection should be worn when 
disposing of lamps or handling broken glass. 


