Owner's Manual

LOW VOLTAGE LIGHTBARS INSTALLATION INSTRUCTIONS
© Copyright 2016. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Page: 3
REV: 01/13/16
a.) When using corner connector or middle connector, please notice the mark on them.
b.) There is a special design on the product--a line on one side of the Lightbar. When linking two bars, please keep the line on the same side.
c.) Constant voltage circuit design support 6m link with tiny light difference.
d.) Please pay attention to the input notice tag when you install the lamp. After having finished installing, please remove it together with the film
membrane on the plastic cover.
2.) Extension cable: by below cable, the Lightbar can be used in any installation situation.
Step 3: When plug in, here there are four kinds of switches for choice.