User's Manual

1716
Note! Electical Facility is Off as default. To activate electrical facility,
AC power of control panel must be on.
Alarm Event/Notification
The alarm system monitors your home for activity and sends you an
app push notification, calling or SMS when sensors are triggered.
All events can be checked by tapping on “Me-Message Center” .
The notification rule is as below. If “Setting-Push Notification”
is disabled, then you will not receive app notifications when events
are detected but still have calling alert and email notification.
Check Event Log
Electrical Facility Control
Home Mode
Sensors that are designated in the Home Zone are deactivated, allowing you to move
freely in your home. the sensors in Normal Zone will remain active and if triggered,
will immediately sound the alarm.
2 Ways to Control the Alarm System
Emergency Call
Press the SOS button in the event of an emergency. This will trigger an immediate
alarm even if the system is disarmed or in Home Mode.
To stop the alarm, press the disarm button on the app or remote control.
Press stay button, then press or button within 3 seconds to enter arm arm disarm
into arming or disarming state in mute mode without disturbing someone.
Mute Mode
Listen into the roon via the control panel and also speak with people in the room.
Two-way Talk
Disarm the system when entering your home. All sensors will be deactivated allowing
you to move freely .
Disarm
Arm the system when leaving your home. All sensors will be activated. Any sensors that
are triggered will immediately sound the alarm.
Arm
You can arm, disarm and switch between security modes using:
1. Smart Life Apps
2. Remote Control
Through the Remote Control
(Press and hold the buttons
for about 1 sec.)
Disarm
Arm
Emergency Call
Home Mode
Tap on device , enter "X1"
the device interface.