User Guide

F/C Mode

This feature sets the control to operate in either the Fahrenheit (F) or

Celsius (C) mode.

NOTE: Changing between Fahrenheit and Celsius will reset the control to

factory default settings.

Software Version

Displays the version of software utilized by the controller.

Process Identier Menu

Process Ident

This feature allows the user to customize the identication of each process

in a program. The identiers are selected from the following list.

Process Identiers™

Default Cure 3 High Spray 4

Bake Cure 4 Preheat Stage 1

Bake 1 Dry Prep Stage 2

Bake 2 Dry 1 Purge Stage 3

Bake 3 Dry 2 Purge 1 Stage 4

Bake 4 Dry 3 Purge 2 Stage 5

Cool down Dry 4 Purge 3 Stage 6

Cook Hold Spray Stage 7

Cure Idle Spray 1 Stage 8

Cure 1 Low Spray 2 Warm-up

Cure 2 Med Spray 3

Other Features

Process Indication Output

The TM02 multifunctional timer control features a Process Indication

Output. Processes 1 thru 7 have a dedicated pair of terminals, labeled

1 thru 7 on the TM02. An indicator (LED, relay coil, etc...) 24 VDC 2 W

maximum can be wired directly to the corresponding terminal block for

each Process to be indicated.

NOTE: Process #8 does not have a dedicated process indication output.

Program Indication Output

Terminal #8 is used to indicate the controller is operating within a Program.

The following voltage will be measured across the #8 terminals:

Controller in the “READY” position

Controller operating in any of the 8 processes making up a Program

0 VDC

24 VDC 2W max

Features