User Guide

Operation

MP2 Process Control System w/

TM02 Multifunctional Timer Control

Switching to the Next Programmed Process

Timed processes

Nothing is required. The MP2 System will immediately proceed to the

next programmed Process after timing out.

NOTE: If the last Process of a program is timed, it will proceed either to the

“READY” position or to the First Process. By selecting the First Process in

the LOOPING Mode menu, the MP2 can be programmed into a continuous

program loop (see page 7, LOOPING Mode).

Untimed (Manual) Processes

An untimed Process will remain in the Process indenitely until Button

1 is pushed and released or TB1 is momentarily latched. Pushing and

releasing Button 1 or the momentary latching of the TB1 will cause the MP2

System to proceed to the next Process. If the last Process of a program

is untimed, pushing and releasing Button 1 or the momentary latching of

TB1 will cause the MP2 system to proceed to the selected program start

position. Multiple contacts used to switch untimed Processes are to be

wired in parallel.

Aborting a Timed Process

Push and release Button 1 or momentarily latch TB1 twice within a 10

second period or latch and hold continuously for 10 seconds.

Connecting Indicator Relays

Process 1 thru 7 indicators use a corresponding pair of terminals, labeled

Relay (1 - 7), on the TM02. The Program indicator uses a corresponding

terminal labeled Relay 8. Wire each indicator (LED, relay coil, etc.) 24

VDC 2 W maximum directly to the desired corresponding terminal. See

gure A, page 18. Note polarity where applicable.