User Guide

F/C Mode

2 Scroll to F/C Mode, press

ENT

3 F/C MODE, scroll to either Fahrenheit or Celsius, press

ENT

4 **Stored** will ash 4 times to conrm entry.

NOTE: Changing between F and C will cause the MP2 system to reset to

factory defaults.

Software Version

2 Scroll to Menu Software Version, press

ENT

3 Software Version information will appear.

Process Identier programming

Process Ident

1 Scroll to the Process Ident Menu, press

ENT

NOTE: Process Identier “Default” will appear. Defaults to Set #1, #2 etc.

2 Select process identier by scrolling to desired identier,

press

ENT

3 Select process # attached to selected identier by scrolling ,

press

ENT

4 **Stored** will ash 4 times to conrm entry.

5 Repeat steps 2 through 4 for other process.

Programming the MP2

MP2 Process Control System

Switching to the Next Programmed Process

Push and release Button 1 on dial face (see page 11) or momentarily

latch (make) a set of contacts wired to the TB1 terminal (i.e. typically

accomplished by a momentary ON (normally open) switch) to proceed to

the next Process. Pushing and releasing Button 1 or momentary latching

of TB1 during the last Process of a program will cause the MP2 System

to return to Process 1. Multiple contacts used to switch Processes are to

be wired in parallel.

Aborting a Process

Same as switching to next Process, push and release Button 1 or

momentarily latch TB1.

Operation