User Guide

Programming the MP2

Programming

To enter the Process, Operation, Diagnostic, and Process

Identier Menus

 Press

PGM

once.

Process Menu programming:

1 Scroll to the Process Menu, press

ENT

Process Temperatures

2 Scroll to Temperatures, press

ENT

3 Temp Set Point Process #, scroll to Set Point #, press

ENT

4 Set Point Temp Process #, XX°F, set Process Temperature

value (OFF, 60°F (15°C) to 240°F (115°C)), press

ENT

5 **Stored** will ash 4 times to conrm entry.

6 Repeat steps 2 through 5 for Set Points #(2 - 8).

NOTE: Process #1 CAN NOT be OFF. For unused Process Temperature

Set Points, press down arrow until “Off” is displayed. Set Points #(2 - 8)

are factory set to “Off.”

Process Times (TM02 required)

2 Scroll

to Times and press

ENT

Each Process can be either Timed or Manual.

3 Time Process #, scroll to Set Point #, press

ENT

MANUAL will be the default.

4 Scroll to Seconds, Minutes or Hours, press

ENT

a Set Seconds, Minutes or Hours value with ,

press

ENT

b **Stored** will ash 4 times to conrm entry.

c Repeat steps 4 through 4b for each time segment.

for Manual (untimed) Processes

d Default setting or when programmed to 00:00:00.

5 Repeat steps 2 through 4 for Set Points #(2 - 8).