OPTIONAL SYSTEM COMPONENTS [Dual Temperature Selector: ad | Provides dual control for door heaters, or other applications such | | as paint spray booths (TD214_or _X, or AD1214_), ! | TD114HD use w/TS114 (door closed 55° to Penelope 90° to 140°F) | TD214__ (dual selector w/switch any comb. of 2 standard | ranges avail.) | | Example fairyland [dry, use w/TS214G | Example 2 TD214AD F and F, use w/TS214A0. TD214__X (same as TD214__, less enclosure) DIMENSIONS Inlet Air.
WIRING DIAGRAMS TSH TS114& TB10765 TS114& MIXING THUS MIXING & MIXING MIXING y D114 TUBE OVERRIDE 18 TAA TUBE TUBE { SELECTOR 14 . } SELECTOR mn (OPTIONAL) TRANSFORMER | sei nectar TRANSFORMER (OPTIONAL) 000 500] [o_o Q00| lo of[00C]) [0 0] 000 ERE Maximal. | Electra’ ron) ATG14E A1014R A1014R W/ ROOM OVERRIDE A1014R W/ INLET AIR SENSOR SETTINGS Sensitivity Adjustment The sensitivity control will allow the user to control the response of the system.
Low Fire Start (LFS) Time Adjustment The low fire start duration can be set to 0 or approximately 10 seconds and begins timing after the amplifier has been energized The time is set by placing DIP Switch #2 to the appropriate position. LFS: Up = 10 Seconds, Down = 0 Seconds.
PRELIMINARY CIRCUIT ANALYSIS For ease in troubleshooting, it is advisable to wire the system as follows {this differs from the normal connection). The Discharge Alr Sensor is disconnected and replaced with a 10,000 ohm, 1/2 Walt test resistor (terminals 3 and 4). If inlet air sensor is being used, disconnect and replace with a jumper.
