User guide

E-DOC-CTC-20090618-0005 v1.0

1 Installation

3 Plug the other end into the Ethernet port of your Internet gateway/modem.

Power on the Thomson Gateway

Proceed as follows:

1 Connect the power cord to the Thomson Gateway’s power port.

2 Plug the other end into an electrical outlet.

3 Push the power button to turn on the Thomson Gateway.

4 Wait two minutes to allow the Thomson Gateway to complete the start up phase.

Connect your computer to the Thomson Gateway

Setting up a wireless connections

For more information on how to setup a wireless connection to your Thomson Gateway, see “3 Wireless

Access” on page 25.

Setting up a wired connection

For more information on how to setup a wired connection (i.e. an Ethernet connection) to your Thomson

Gateway, see “1.4 Connecting a Computer Using the Ethernet Cable” on page 14.

Configure the Thomson Gateway

Proceed as follows:

1 Open your web browser.

2 The Thomson Gateway informs you that you have not yet configured your Thomson Gateway.

If this window does not appear browse to http://dsldevice.lan

or to the IP address of your Thomson

Gateway (by default: 192.168.1.254

) and click Thomson Gateway on the menu on the left-hand side.

3 Click Setup my Thomson Gateway.

4 The Easy Setup wizard appears. This wizard will guide you through the configuration of your Thomson

Gateway. Click Next and follow the instructions.

The WAN port can only be used to connect your Thomson Gateway to an Internet gateway/modem.

You can not use it to connect your computer to the Thomson Gateway.