Installation Guide

For 6” housings

Step 1 (Fig. 1)

Remove existing trim and CFL or incandescent bulbs.

Screw adapter (B) into socket in recessed housing.

Step 2 (Fig. 2a)

Plug base cable connector into lamp

(A).

Step 3 (Fig. 2b)

Carefully route wires into ﬁxture. Push

retroﬁt into recessed housing until the

trim is ﬂush with the ceiling surface.

Fig. 1

Fig. 2

a b

This lamp can be installed into 5 in. and 6 in. housings.

Before beginning assembly of product, make sure all parts are present. Compare parts with package contents l

ist. If any part

is missing or damaged, do not attempt to assemble the product. NOTE: Product is shipped in the 6” installation conﬁguration.

If installing in a 6” housing with ears, no adjustments are necessary. However, if installing in a 6” housing without ears or a 5”

housing, the appropriate instructions must be followed.

Tools required for assembly (not included): Phillips screwdriver

PREPARATION

INSTALLATION