User Manual

model no. 054-2092-0 | contact us 1-888-670-6682

OPERATING INSTRUCTIONS

ADJUSTABLE DEPTH GAUGE

Fit the drill bit into the chuck. Loosen the depth

gauge by rotating the handle grip counter-clockwise.

Slide the depth gauge until the distance between the

depth gauge end and the drill bit end is equal to the

depth of the hole you wish to make. Then clamp the

depth gauge by rotating the handle clockwise.

FUNCTION MODE SELECTION (Fig D)

The operation of the gearbox for each application is

set with the function mode selection switch (4). To

change between functions, depress the unlocking

button (12) and rotate the selector to the desired

operating mode.

For simultaneous drilling and impacting

of concrete or masonry, choose the

hammer drilling position.

For drilling into steel, wood and

plastics, choose the rotary drilling

position.

For impacting only: for light chipping,

chiselling and demolition applications

choose the hammer position.

WARNING!

The operating mode selector switch may be actuated only at a standstill.

WARNING!

Prolonged use will cause the aluminum housing to become hot: do not touch.

WARNING!

Before installing accessory, remove plug from power supply. Do not attempt

to tighten drill bits (or any other accessory) by gripping the front part of the

chuck and turning the tool on. Damage to the chuck and personal injury may

result.

FPO

Fig. A

Fig. C

Fig. B

Fig. D