User Manual

14
model no. 054-2092-0 | contact us 1-888-670-6682
OPERATING INSTRUCTIONS
INTENDED USE
The hammer is intended for hammer drilling in
concrete, brick and stone as well as for light chiselling
work. It is also suitable for drilling without impact in
wood, metal, ceramic and plastic.
INSERTING/REPLACING THE KEYED
CHUCK ADAPTOR (FIG. A)
Inserting the keyed chuck adaptor
To work with tools without SDS-Plus (e.g., drills with
cylindrical shank), a suitable keyed chuck adaptor (10,
not supplied) must be installed. Insert the shank (11) of
keyed chuck adapter with a twisting motion into the
SDS-Plus chuck (8) until it can be heard to lock. The
keyed chuck adapter locks itself. Check the locking by
pulling on the drill chuck.
Removing the keyed chuck adaptor
To remove the keyed chuck adaptor (10), pull the
locking sleeve (7) to the rear, hold in this position,
and remove the keyed chuck adaptor from the SDS-
Plus chuck.
INSERTING AND REMOVING DRILL BIT IN SDS
Take care that the dust protection cap (6) is not
damaged when changing tools.
INSERTING
Clean and lightly oil the bit before inserting. Insert the
dust-free bit into the bit holder with a twisting motion
until it latches.
The bit locks itself. Check the locking by pulling on
the tool.
REMOVING
Retract back the bit holder locking sleeve (7) and pull
out the bit.
NOTE: Before using the tool, read the instruction book carefully.
Fig. A
Fig. C
Fig. B
1
2
Fig. D
10
11
7
12
WARNING!
Your new rotary hammer drill generates powerful forces to get your job done
quickly and effectively. These forces may cause inferior quality SDS bits to
break and jam in the chuck. We therefore recommend that only high quality
SDS bits be used with this tool.
FPO