User Manual

WORKING HINTS FOR YOUR TOOL

• If your power tool becomes too hot, please run your circular saw no load for

2-3 minutes to cool the motor. Avoid prolonged usage at very low speeds.

• Protect saw blades against impact and shock. Cutting with extreme force can

significantly reduces the performance capability of the tool and reduces the

service life of the saw blade. Sawing performance and cutting quality depend

essentially on the condition and the tooth count of the saw blade. Therefore,

use only sharp saw blades that are suited for the material being cut.

• Choice of blades: 24 teeth for general work; approx. 44 teeth for finer cuts;

more than 44 teeth for very fine cuts into delicate surfaces. Use diamond

blades for tile, cement board, etc.

• Only use saw blades recommended.

The table below gives you advice on how to choose correct blade.

Blade type Cutting material

TCT 24T Wood and aluminum

HSS 44T Thin sheet steel and aluminum, PVC pipe, plastic

Diamond Concrete, marble, tile, cement backerboard

Recommended maximum material thickness

Wood 1-1/16˝

Aluminum 1/8˝

PVC pipe (radius) 1/12˝

Tile 5/16˝

Sheet steel 1/32˝ (20 gauge)