User Manual

model no. 054-6963-4 | contact us 1-888-670-6682

OPERATING INSTRUCTIONS

REPLACING LASER BATTERIES (See Fig. F1,

F2, F3 )

The saw comes with laser batteries pre-installed. When

battery capacity runs out, replace batteries as follows:

Use 1.5 V batteries model LR44, typical to calculators,

cameras and similar small electronics.

Move the battery storage cover in the direction the

arrow (on the cover) points. Then lift the battery

storage cover.

You can see one end of a cord. To remove the batteries

(20), just slowly pull the end of the cord. The two

batteries will be taken out along with the cord.

To fit new batteries, adjust the position of the cord and

insert two batteries in place. Make sure two batteries

are pressed on the cord. Restore the cover.

NOTE: Pay attention that “+/-” of the batteries are the same as the

illustration on the machine.

Fig. F1

Fig. F2

Fig. F3

Fig. H2

Fig. I

Fig. H1

Fig. G1

Fig. G2