User Manual

Use only extension cords that are intended for outdoor use. These extension

cords are identified by a marking Acceptable for use with outdoor appliances.

store indoors while not in use. Use only extension cords having an electrical rating

compatable with the rating of the product. Do not use damaged extension cords.

Examine the extension cord before using and replace if damaged. Do not abuse

extension cords, and do not yank on any cord to disconnect. Keep cord away from

heat and sharp edges. Always disconnect the extension cord from the receptacle

before disconnecting the product from the extension cord.

Ground Fault Circuit Interrupter (GFCI) protection should be provided on the

circuit(s) or outlet(s) to be used for the tile saw. Receptacles are available having

built-in GFCI protection and may be used for this measure of safety.

EXPLANATION OF THE TERMS USED IN THE INSTRUCTION

Through-sawing: sawing a workpiece into 2 separated parts.

Push-stick: a special stick that is used to push the workpiece towards the saw.

Freehand: hand without any protection such as gloves etc.

Kickback: a sudden reaction to a pinched or snagged rotating wheel, backing pad,

brush or any other accessory. Pinching or snagging causes rapid stalling of the

rotating accessory which in turn causes the uncontrolled power tool or workpiece

to be forced in the direction opposite of the accessory’s rotation at the point of the

binding.

Additional safety warning for class 2 laser

The laser device fitted to this tool is CLASS 2 with a maximum radiation of 1.5 mW

and 650 nm wavelength.

CLASS 2 LASER RADIATION—DO NOT STARE INTO BEAM

ADDITIONAL SAFETY WARNINGS FOR ALL SAWS