User Manual

12
model no. 054-3245-2 | contact us 1-888-670-6682
13
TM
FITTING AND REMOVING THE BATTERY PACK TO THE
IMPACT WRENCH
•Toinstallthebatterypacktothetool,aligntheraised
portion of the battery pack with the grooves on the
bottom of the tool, and slide it firmly into the handle until
you hear the lock snap into place. (Fig. A)
•Toremovethebatterypackfromthetool,pressthe
battery pack release button and slide the battery pack
completely out of tool handle.
CHARGING PROCEDURE
•Connecttheplugcabletothecharger,andthenpluginto
an appropriate outlet before inserting battery pack (Fig. B).
All three charging lights will be on for two seconds and then
off.
•Insertthebatterypackintothecharger,makingsurethe
pack is fully seated in the charger (Fig. C). During the
charging process, the charging lights will indicate the
chargingstatusasfollows:
-Lessthan30%charged:allthreecharginglightswill
blink in sequence.
-Lessthan60%charged:onelightwillstayon,whilethe
OPERATING INSTRUCTIONS
other two lights will blink in sequence.
-Over60%charged:twolightswillstayon,whilethe
remaining light will blink continuously.
-Fullycharged:allthreelightswillremainon
continuously.
•Thechargingprocesswilllastapproximately35minutes
and continuous lighting of all three charging lights will
indicate charging is complete.
CHARGER DIAGNOSTICS
The charger is designed to detect certain problems that can
arise with battery packs
•Whenthechargerdetectsthebatterypackisoverheated,
all three charging lights will blink at the same time. Please
remove the battery and allow it to cool down for 15–30
minutes and re-insert.
•Whenthechargerdetectsamalfunctioninthebattery,two
charging lights will blink at the same time. Please remove
the battery and allow it to cool down for 15–30 minutes.
Then re-insert the battery pack into the charger. If two
charging lights still flash, the battery may require service.
•Whenthechargerdetectsamalfunctionofthecharger
itself, three charging lights will blink at the same time.
Please remove the battery pack and unplug the charger for
at least 2 minutes. After 2 minutes, plug charger back in
and re-insert the pack into the charger. If all three charging
lights still blink at the same time, the charger may require
service.
ON/OFF TRIGGER SWITCH
To turn the tool on, squeeze the trigger switch. To turn the tool
off, release the trigger switch.
OPERATING INSTRUCTIONS
WARNING!
•Donotallowfamiliaritywithtoolstomakeyoucareless.
Remember that a careless fraction of a second is enough to
cause serve injury.
•Beforeattemptingtousethiscordlesstool,becomefamiliar
with all of its operating features and safety requirements.
•Toreducetheriskofseriouspersonalinjury,turntooloff
and disconnect battery pack before making any adjustments
or removing/installing attachments or accessories.
CAUTION!
•Beforeattemptingtochargethebattery,checkthecharger
and the battery to ensure the charging equipment matches
the battery supplied. The components are all labeled with
component numbers.
•Therechargeablebatteryisnotfullychargedonleavingthe
factory. Charge the rechargeable battery before first use.
•Rechargedischargedbatteriesassoonaspossibleafteruse
or battery life may be greatly diminished. For longest battery
life, do not discharge batteries fully.
CAUTION!
The working temperature of the charger is 32 to 113°F
(0 to 45°C).
NOTE: Charging times may be longer depending on the
surrounding temperature and battery condition.