User Manual

Fig. B
Fig. A
This MAXIMUM
®
Air-powered Stapler drives 18-gauge 1/4’’ narrow
5/8 1 1/2" (15 38 mm) long staples.
DANGER!
Potential hazard that could result in serious injury or loss of
life.
• Disconnect the tool from the compressed air source before
loading staples.
• Do not point the tool towards the operator or other people
while changing staples.
• Do not hold the tool with the trigger pressed while
changing the staples . Failure to comply will result in serious
injury or loss of life.
WARNING!
Potential hazard that could result in serious injury or loss of
life.
• The use of any other types of staples will cause the stapler to
jam and could lead to serious injury or loss of life.
NOTE: Icons are colour coded. Please refer to the actual tool
for the specific colour.
2. Hold the Air-powered Stapler firmly
with one hand. Use the other hand
to press the latch (1) on the magazine
(2) and slide it back (Fig. B).
1. Disconnect the tool (1) from the air
supply (2) (Fig. A).
1514
model no. 058-9841-8 | contact us 1-888-670-6682
STAPLE TYPE ICONS
COMPATIBLE STAPLES:
ACCEPTABLE STAPLES
Length: 5/8 to 1 1/2" (15 to 38 mm)
These icons are used to select the proper staples for this specific
Loading Staples
1
2
3. Make sure you have the right staples for your
tool (page 14). Load a strip of staples (1)
into magazine. Push magazine forward
until it latches.
The tool is now ready for use (Fig. C).
Fig. C
2
1
Fig. D
1
2
5/8 - 1 1/2
1
4. Plug in compressor, turn it on, set the pressure
regulator to 90 PSI, and attach one end of the air
hose to the compressor and the other end of the
air hose (1) to the tool (2). Use plumber’s tape to
prevent air leaks (Fig. D)
1/4
1/4
R
stapler.
STAPLE SIZE :
crown
STAPLES