User Manual

model no. 054-3213-8 | contact us 1-888-670-6682
14 15
TM
ON/OFF TRIGGER SWITCH
To turn the tool on, squeeze the trigger switch. To turn the tool off, release the trigger
switch.
VARIABLE SPEED
The variable speed trigger switch delivers higher speed with increased trigger pressure
and lower speed with decreased trigger pressure. Use the variable speed to start
screwing tasks, then fully press the trigger switch once the task has started.
FORWARD AND REVERSE
The direction of bit rotation is reversible and is controlled by a selector located above
the trigger switch. Screwing in uses the forward mode. The reverse mode is intended
for the removal of screws. (Fig. D)
Withtheimpactdriverheldinnormaloperatingpositions:
•Positiontheforward/reverseselectortotheleftofthetool
for forward.
•Positiontheforward/reverseselectortotherightofthe
tool for reverse.
•Positiontheforward/reverseselectorinthecentreto
lock the switch trigger to help reduce the possibility of
accidental starting when not in use.
LED WORKLIGHT
When the unit is switched on, the LED worklight illuminates to ensure better vision
and to make working in dark areas safer. The LED work light goes off after the trigger
switch is released.
INSTALLING AND REMOVING BITS
•Yourtoolisequippedwithaquickreleasechuck.Toinsertanaccessory,simplypull
Locking Sleeve
Chuck
OPERATING INSTRUCTIONS
the locking sleeve forward, insert the desired accessory
into the chuck and release the locking sleeve. (Fig. E)
•Toremoveanaccessory,pullthelockingsleeveforward
and simply remove the accessory from the chuck.
•Toavoidlossofcontrol,ensurethebitislockedintothe
chuck by pulling on the bit after it has been inserted.
REMAINING POWER INDICATOR
If the trigger switch is pressed, the remaining power indicator
lights and the battery’s remaining power can be checked.
When you release your fingers from the trigger switch, the
remaining power indicator goes off.
LED INDICATOR REMAINING POWER STATUS
1 0–25 %
2 25–50 %
3 50–75 %
4 75–100 %
BELT HOOK
The belt hook is used to hang the tool from your waist belt
while working. Install the belt hook securely in the groove of
the drill and tighten the screw to fix the hook firmly. (Fig. F)
TEMPERATURE CUT-OUT
When used as intended, the driver cannot be subjected to
overload. But running continuously at full load for a long time
OPERATING INSTRUCTIONS
CAUTION!
To prevent gear damage, always allow the chuck to come to a
complete stop before changing the direction of rotation.
CAUTION!
•Whenusingthebelthook,hangthepowertoolfirmlysoas
not to drop it accidentally. If the power tool is dropped, it
may lead to an accident.
•Whencarryingthetoolhookedtoyourwaistbelt,donot
fit any bit to the top of the power tool, as this may lead to
accidental injury
WARNING!
Do not insert or remove bits while the tool is activated. Make sure
the battery pack is removed or the forward & reverse lever is in
the centre locking position when inserting or removing bits.
NOTE: This tool is equipped with an electric brake. When the brake
is functioning properly, sparks may be visible through the vent slots
in the housing. This is normal and is the action of the brake.
NOTE: The impact driver will not run unless the direction of
forward/reverse selector is engaged fully to the left or right.