Specifications

Initial set-up of the equipment
MCE 0111, TR 0111 TR 2502
1 Point signals away from the road so they Align the signals and MVDs – see pages 5, 6,
cannot be seen by drivers. 12 to 14.
2 Connect the signal heads and power supply Connect the signal heads and power
to the controller. supply to the controller.
3 Set the controller to ‘MANUAL’. Set the ‘All-Red’ controls – see pages 7 to 9.
4 Set the ‘All-Red’ controls – see pages 7 to 9. Set the ‘Maximum Green’ controls – see
pages 7, 8 and 10.
5 Set the ‘Maximum Green’ controls – see Set the controller to Vehicle Actuated (VA).
pages 7, 8 and 10.
6 Switch on signal heads and go to page 16. Switch on signal heads. On some controllers
this may be achieved by selecting VA. Go to
page 16.
Controllers to 027-008-024 – consult the instructions for the equipment.
15