Installation Guide

- 14 - Maximal3V / Maximal5V / Maximal7V Access Power Controllers (Fused) Installation Guide
CUT
JUMPER
FROM FACP
OUTPUT
CIRCUIT
+
--
FACP
OUTPUT EOL
TRG
FACP
NO C NC
FACP INTERFACE
FACP Hook-Up Diagrams:
Fig. 8 Polarity reversal input from FACP signaling circuit output (polarity is referenced in alarm condition):
N.O. TRIGGER
INPUT
TRG
FACP
NO C NC
FACP INTERFACE
Fig. 9 Normally Open - Non-Latching FACP trigger input:
N.C. RESET
SWITCH
N.O.
TRIGGER
INPUT
JUMPER
TRG
NO C NC
FACP
Fig. 10 Normally Open FACP Latching trigger input with reset: