Installation Guide

- 10 - Maximal3V / Maximal5V / Maximal7V Access Power Controllers (Fused) Installation Guide
+ BAT -
L G N BAT FAIL NC C NO NC C NO AC FAIL
AC
DC
- DC +
OUTPUT 1 OUTPUT 2 OUTPUT 3 OUTPUT 4 OUTPUT 5 OUTPUT 6 OUTPUT 7 OUTPUT 8
NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM
IN GND IN GND IN GND IN GNDIN GND IN GND IN GND IN GND
1 2 3 4
5 6 7 8
INPUT
TRIGGER
10A 250V
+INP- T + RET-
NO C NC
FACP INTERFACE
Power Control
- + - +
F1 F2 F3 F4 F5 F6 F7 F8
MAIN
TRG
FACP
1 2 3 4
1 2 3 4
ON
ON
1 2 3 4
1 2 3 4
ON
ON
OUTPUT 1 OUTPUT 2 OUTPUT 3 OUTPUT 4 OUTPUT 5 OUTPUT 6 OUTPUT 7 OUTPUT 8
NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM
IN GND IN GND IN GND IN GNDIN GND IN GND IN GND IN GND
1 2 3 4
5 6 7 8
INPUT
TRIGGER
10A 250V
+INP- T + RET-
NO C NC
FACP INTERFACE
Power Control
- + - +
F1 F2 F3 F4 F5 F6 F7 F8
MAIN
TRG
FACP
1 2 3 4
1 2 3 4
ON
ON
1 2 3 4
1 2 3 4
ON
ON
Optional
Rechargeable
Stand-by Battery
Optional
Rechargeable
Stand-by Battery
24VDC Operation:
connect two (2) 12VDC batteries in series
Input 220VAC
50/60Hz
Line Neutral
Tamper Switch
Keep power-limited wiring separate from non power-limited. Use minimum 0.25” spacing. Up to four (4) 12AH rechargeable batteries are the largest batteries that can fit in this enclosure. An external battery enclosure must be used if using the 40AH or 65AH batteries.
Ground Lug
Fig. 4 - Maximal7V
Fig. 4a
Tamper Switch
(not included)
To Access Control Panel or
UL Listed Reporting Device
Edge of
Enclosure
Enclosure