Specifications

MORRIS Industries Ltd.
5-10
Operation
Depth Stop Adjustment
The Morris Maxim Air Drill is equipped with
mechanical depth stops. The mechanical depth
stops ensures positive depth of each frame section,
unaffected by any leaks in the system. (i.e. leaking
couplers, internal cylinder leaks, etc.)
Mechanical Depth Stop
• To increase or decrease the working depth, adjust
all the stroke control collars evenly across the
whole machine.
a) 1 turn on the collar changes the depth
approximately 3/16”.
b) 6 turns on the collar changes the depth
approximately 1”.
• The optional spacer may be required when seeding
shallow. These spacers are available under part
number S25999 through the Parts Department.
Rephasing
• Raise machine fully, holding hydraulic lever for
several seconds to phase the system.
• This will maintain equal pressure, cylinder stroke,
and synchronize cylinders.
• It is recommended that the unit be rephased
at each turn on the headland.
Oil Level
The hydraulic system draws its oil supply from the
tractor reservoir.
• Check the oil level after the cultivator system has
been filled.
• Refer to tractor operators manual for more
information.
Stroke Control Collars
RETAINING PIN
STROKE CONTROL COLLAR
OPTIONAL SPACER