36 in. User Manual
9
TRANSMITTER SETTING (MODEL: FCT6000WT)
1) Open the transmitter battery cover and install DC3V battery. (Model: CR2032)
2) Turn on the power of the light fan.
3) Within 30 sec after the “Beep”, press and hold the LEARN button for 3 sec. (Don’t press any
other buttons.) Once the receiver has detected and learned the frequency, the receiver will
“Beep” twice mean while the light will bright out twice.
4) Programming/self-learning process is completed and transmitter is ready to use.
5) Dial up to position “D”, the brightness of the light can be control low or high. NOTE: This
option is not applicable for non-dimming products.
ATTENTION
1) After completing the steps above, you should be able to operate the fan and light. If the fan
and light are not responding to the transmitter, please turn the power off to the light fan and
repeat step 2 and 3.
2) Iflongtimenottousethetransmitter,pleasetakethebatteryout.
TRANSMITTER FUNCTION
CR2032
D
O
D
O
OD switch
LEARN button